[Soekris] BootDrive = 80 FF FF FF

[Lars Noodén]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

A Net4801 unit I have is not letting me do PXE boot.
Which of the settings get changed to allow PXE boot again?

 comBIOS ver. 1.33  20080103  Copyright (C) 2000-2007 Soekris  Engineering.

 net4801

 0256 Mbyte Memory                        CPU Geode SC1100 267 Mhz

 Pri Sla  ULTIMATE CF CARD 1GB            LBA Xlt 1007-32-63  1015 Mbyte

 Slot   Vend Dev  ClassRev Cmd  Stat CL LT HT  Base1    Base2   Int
 -------------------------------------------------------------------
 0:00:0 1078 0001 06000000 0107 0280 00 00 00 00000000 00000000
 0:06:0 100B 0020 02000000 0107 0290 00 3F 00 0000E101 A0000000 10
 0:07:0 100B 0020 02000000 0107 0290 00 3F 00 0000E201 A0001000 10
 0:08:0 100B 0020 02000000 0107 0290 00 3F 00 0000E301 A0002000 10
 0:10:0 104C AC23 06040002 0107 0210 08 3F 01 00000000 00000000
 0:18:2 100B 0502 01018001 0005 0280 00 00 00 00000000 00000000
 0:19:0 0E11 A0F8 0C031008 0117 0280 08 38 00 A0003000 00000000 11
 1:00:0 100B 0020 02000000 0107 0290 00 3F 00 0000D001 A4000000 05
 1:01:0 100B 0020 02000000 0107 0290 00 3F 00 0000D101 A4001000 11

	 5 Seconds to automatic boot.   Press Ctrl-P for entering Monitor.

	comBIOS Monitor.   Press ? for help.

	> show

	ConSpeed = 19200
	ConLock = Enabled
	ConMute = Disabled
	BIOSentry = Enabled
	PCIROMS = Disabled
	PXEBoot = Enabled
	FLASH = Primary
	BootDelay = 5
	FastBoot = Disabled
	BootPartition = 3
	BootDrive = 80 F0 FF FF
	ShowPCI = Enabled
	Reset = Hard
	CpuSpeed = Default

	> boot f0

	No Boot device available, enter monitor.


	comBIOS Monitor.   Press ? for help.


Regards,
- -Lars
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (GNU/Linux)

iEYEARECAAYFAklf0dsACgkQfz2bZ9qH75o0kQCfRkLsKkCbQiAajQrTb6rXb1Th
xMcAnRgq4l4VamYLQKt7e5q5+PTyBEKS
=81ZJ
-----END PGP SIGNATURE-----