[Soekris] Lexar CF 8Gb 300x UDMA

[Roberto Fichera]

Hi All on the list,

I'm trying to get working a Lexar CF 8Gb 300x UDMA using a net5501-70.
ComBIOS v1.33 reports the CF as below, but only a after issue a reboot
command
from the ComBIOS prompt:

Pri Mas  LEXAR ATA FLASH CARD            LBA Xlt 972-255-63  7815 Mbyte

Below there are my settings

ConSpeed = 57600
ConLock = Enabled
ConMute = Enabled
BIOSentry = Enabled
PCIROMS = Enabled
PXEBoot = Disabled
FLASH = Primary
BootDelay = 5
FastBoot = Disabled
BootPartition = Disabled
BootDrive = 80 81 F0 FF
ShowPCI = Enabled
Reset = Hard
CpuSpeed = Default

Whenever I get it to boot the kernel 2.6.26.5-28.fc8 reports the CF as

scsi0 : pata_cs5536
scsi1 : pata_cs5536
ata1: PATA max UDMA/100 cmd 0x1f0 ctl 0x3f6 bmdma 0xe000 irq 14
ata2: DUMMY
ata1.00: CFA: LEXAR ATA FLASH CARD, 20071016, max UDMA/100
ata1.00: 15630048 sectors, multi 0: LBA
ata1.00: limited to UDMA/33 due to 40-wire cable
ata1.00: configured for UDMA/33
scsi 0:0:0:0: Direct-Access     ATA      LEXAR ATA FLASH  2007 PQ: 0 ANSI: 5
sd 0:0:0:0: [sda] 15630048 512-byte hardware sectors (8003 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't
support DPO or FUA
sd 0:0:0:0: [sda] 15630048 512-byte hardware sectors (8003 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't
support DPO or FUA
 sda: sda1 sda2 sda3
sd 0:0:0:0: [sda] Attached SCSI removable disk

So the question is does the above Lexar CF works with suck net5501-70?
Does it's supported or not?

Thanks in advance.
Roberto Fichera.