[Soekris] PXE Installation of OpenBSD 4.2 on Soekris 4801

[Chris Cappuccio]

at the boot> prompt, you need to use the following commands to enable
the serial terminal:

set tty com0
stty com0 19200

and in /etc/ttys, tty00 should look like this:

tty00   "/usr/libexec/getty std.19200"  vt100   on  secure

Lars Nood??n [lars at umich.edu] wrote:
> I'm working with a new Soekris 4801 w/256MB RAM and wonder about getting
> OpenBSD installed so that the system boots.  Once I can get to SSH, I'm
> home free.
> 
> Netboot using PXE and tfptd goes well: I've gotten things set up so I
> can do the net boot + install and that whole installation procedure
> appears to run flawlessly.
> 
> However, when I get to booting the installed system, things just appear
> to hang.  Here is the output from the serial connection just before that
> happens:
> 
> 	http://www-personal.umich.edu/~lars/net4801.txt
> 
> Where can I find info about how OpenBSD needs to be configured
> differently from your average tower/rack mounted system so as to boot
> from CF with no HD?
> 
> Regards
> -Lars
> 
> _______________________________________________
> Soekris-tech mailing list
> Soekris-tech at lists.soekris.com
> http://lists.soekris.com/mailman/listinfo/soekris-tech

-- 
"You were about to change the channel when God healed you" -- Benny Hinn