[Soekris] 5501 boot problem

Wed Aug 15 21:26:22 UTC 2007

I try to boot my brand new 5501 with a CF flash working on
 various 4801 (Debian etch)

The boot stop after those lines

Begin: Mounting root file system... ...
Begin: Running /scripts/local-top ...
hda: Flash Card, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Done.
Begin: Waiting for root file system... ...

.... and after three minutes drop me to a busybox shell

Done.
        Check root= bootarg cat /proc/cmdline
        or missing modules, devices: cat /proc/modules ls /dev
ALERT! /dev/hda1 does not exist. Dropping to a shell!

BusyBox v1.1.3 (Debian 1:1.1.3-3) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

/bin/sh: can't access tty; job control turned off

.... a cat of /proc/partitions show no partition at all,
 and ad the message saud hda doesnt exists

Any suggestion ? Attached the whole bootlog

Ciao.   Marco

============================================================

Linux version 2.6.15-1-486 (Debian 2.6.15-8) (waldi at debian.org) (gcc
version 4.0.3 2006026
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000020000000 (usable)
 BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
512MB LOWMEM available.
DMI not present.
ACPI: Unable to locate RSDP
Allocating PCI resources starting at 30000000 (gap: 20000000:dff00000)
Built 1 zonelists
Kernel command line: root=/dev/hda1 ro console=ttyS0,9600n8
No local APIC present or hardware disabled
Initializing CPU#0
PID hash table entries: 4096 (order: 12, 65536 bytes)
Detected 500.015 MHz processor.
Using tsc for high-res timesource
Console: colour dummy device 80x25
Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
Memory: 511344k/524288k available (1516k kernel code, 12348k reserved,
574k data, 228k in)
Checking if this processor honours the WP bit even in supervisor mode...
Ok.
Calibrating delay using timer specific routine.. 1001.34 BogoMIPS
(lpj=500672)
Security Framework v1.0.0 initialized
SELinux:  Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
CPU: L1 I Cache: 64K (32 bytes/line), D cache 64K (32 bytes/line)
CPU: L2 Cache: 128K (32 bytes/line)
mtrr: v2.0 (20020519)
CPU: AMD Geode(TM) Integrated Processor by AMD PCS stepping 02
Checking 'hlt' instruction... OK.
checking if image is initramfs... it is
Freeing initrd memory: 4825k freed
NET: Registered protocol family 16
EISA bus registered
PCI: PCI BIOS revision 2.01 entry at 0xfac61, last bus=0
PCI: Using configuration type 1
ACPI: Subsystem revision 20050902
ACPI: Interpreter disabled.
Linux Plug and Play Support v0.97 (c) Adam Belay
pnp: PnP ACPI: disabled
PnPBIOS: Scanning system for PnP BIOS support...
PnPBIOS: PnP BIOS support was not detected.
PCI: Probing PCI hardware
audit: initializing netlink socket (disabled)
audit(1187511505.632:1): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
PNP: No PS/2 controller found. Probing ports directly.
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
EISA: Probing bus 0 at eisa.0
EISA: Detected 0 cards.
NET: Registered protocol family 2
IP route cache hash table entries: 32768 (order: 5, 131072 bytes)
TCP established hash table entries: 131072 (order: 7, 524288 bytes)
TCP bind hash table entries: 65536 (order: 6, 262144 bytes)
TCP: Hash tables configured (established 131072 bind 65536)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 8
NET: Registered protocol family 20
Using IPI Shortcut mode
Freeing unused kernel memory: 228k freed
Loading, please wait...
Begin: Loading essential drivers... ...
Done.
Begin: Running /scripts/init-premount ...
FATAL: Error inserting fan
(/lib/modules/2.6.15-1-486/kernel/drivers/acpi/fan.ko): No suce
FATAL: Error inserting thermal
(/lib/modules/2.6.15-1-486/kernel/drivers/acpi/thermal.ko)e
via-rhine.c:v1.10-LK1.2.0-2.6 June-10-2004 Written by Donald Becker
eth0: VIA Rhine III (Management Adapter) at 0x1e100, 00:00:24:c8:da:80,
IRQ 11.
eth0: MII PHY found at address 1, status 0x7849 advertising 05e1 Link
0000.
eth1: VIA Rhine III (Management Adapter) at 0x1e200,
00:00:24:c8:<7>spurious 8259A interr.
da:81, IRQ 5.
eth1: MII PHY found at address 1, status 0x7849 advertising 05e1 Link
0000.
eth2: VIA Rhine III (Management Adapter) at 0x1e300, 00:00:24:c8:da:82,
IRQ 9.
eth2: MII PHY found at address 1, status 0x7849 advertising 05e1 Link
0000.
eth3: VIA Rhine III (Management Adapter) at 0x1e400, 00:00:24:c8:da:83,
IRQ 12.
eth3: MII PHY found at address 1, status 0x7849 advertising 05e1 Link
0000.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
AMD5536: IDE controller at PCI slot 0000:00:14.2
AMD5536: chipset revision 1
AMD5536: not 100% native mode: will probe irqs later
AMD5536: 0000:00:14.2 (rev 01) UDMA100 controller
AMD5536: neither IDE port enabled (BIOS)
usbcore: registered new driver usbfs
usbcore: registered new driver hub
ehci_hcd 0000:00:14.5: EHCI Host Controller
ohci_hcd 0000:00:14.4: OHCI Host Controller
ohci_hcd 0000:00:14.4: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:14.4: irq 15, io mem 0xa0005000
ehci_hcd 0000:00:14.5: new USB bus registered, assigned bus number 2
ehci_hcd 0000:00:14.5: irq 15, io mem 0xa0006000
ehci_hcd 0000:00:14.5: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 4 ports detected
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 4 ports detected
Done.
Begin: Mounting root file system... ...
Begin: Running /scripts/local-top ...
hda: Flash Card, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Done.
Begin: Waiting for root file system... ...

Done.
        Check root= bootarg cat /proc/cmdline
        or missing modules, devices: cat /proc/modules ls /dev
ALERT! /dev/hda1 does not exist. Dropping to a shell!

BusyBox v1.1.3 (Debian 1:1.1.3-3) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

/bin/sh: can't access tty; job control turned off

-- 
Marco A. Calamari <marcoc1 at dada.it>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 307 bytes
Desc: This is a digitally signed message part
Url : http://lists.soekris.com/pipermail/soekris-tech/attachments/20070815/276dc17c/attachment-0001.bin