[Soekris] Can't access serial console, but boots OK

[Stuart Henderson]

On 2007/04/28 17:13, Jan Ceuleers wrote:
> 
> Another point: I'm not familiar with monowall, but if it is Linux-based 
> and you can log into it, try issuing the following command:

FreeBSD-based; actually, thinking about it - since m0n0wall prints
to the console while booting, even if fastboot=on you'll still usually
see some output if the cable is wired correctly (readable if the speed
is correct, garbled otherwise - possible exception being if one side
is set to 115200 and the other isn't).

If it's possible to test with a multimeter, pin 2 at one side must
connect to pin 3 at the other (and vice-versa).