[Soekris] Asterisk FXO
Matt Ryanczak
ryanczak at gmail.com
Sun Aug 20 15:06:04 UTC 2006
I don't believe that a TDM400P will work in a 4801. For one the tdm400p is a
big card, it will not fit in the standard soekris case. Also, the TDM400p
requires one of the big molex (12/5 volt) power connections from the PC
power supply which the soekris can not provide with its default power supply
/ setup.
You can use a wildcard single FXO card but be sure you get the right kind,
some of the wildcard clones out there do not support the right PCI voltage
and will not work in a 4801.
-Matt
On 8/17/06, Kannaiyan Natesan <gbpnkans at gmail.com> wrote:
>
> Any test gone with TDM400P with 4 calls on a PCI bus with IAX on the
> FXO ports or SIP Protocol.
>
> Regards,
> Kannaiyan
>
> On 8/18/06, Jason Clark <jason at jasonandjessi.com> wrote:
> > That's pretty much the same thing Im going for. SIP into the 4521, IAX
> > out, single call.
> >
> > Ken wrote:
> > > On 8/17/06, Jason Clark <jason at jasonandjessi.com> wrote:
> > >> Asterisk runs on the WRT54G, so Im sure it will run on a Soekris
> board.
> > >> Now, how many calls you can terminate, that is a different story. Im
> > >> installing asterisk on a Net4521 once my CF card shows up, I'll post
> if
> > >> it works.
> > >
> > > I have been running it on 4801 for quite some time without any
> > > problems. However I am only using SIP and IAX connections, no FXO. Its
> > > been fine with the light call volume it handles. No more than 2 to 3
> > > simultaneous.
> > >
> > > -Ken
> > >>
> > >> Kannaiyan Natesan wrote:
> > >> > Hi Graham,
> > >> >
> > >> > Thanks for your input.
> > >> > You don't need a SPA 3000 when you have a motherboard with PCI
> Slot.
> > >> > You can add an asterisk FXO card to cover that process. I don't
> think
> > >> > SIPURA is of that much good quality in voice compared to asterisk
> FXO.
> > >> >
> > >> > Regards,
> > >> > Kannaiyan
> > >> >
> > >> > On 8/18/06, Graham Menhennitt <gmenhennitt at optusnet.com.au> wrote:
> > >> >
> > >> >> Kannaiyan Natesan wrote:
> > >> >>
> > >> >>> I want to have 4 port asterisk FXO card to go with asterisk.
> > >> What
> > >> >>> is the suitable motherboard from soekris and How would i buy
> them?
> > >> >>>
> > >> >>>
> > >> >> I am not an expert on this but I have doubts that any Soekris card
> is
> > >> >> powerful enough to do the analogue processing for VoIP. I do it by
> > >> >> off-loading the analogue bit to a Sipura SPA 3000 which I connect
> > >> to a
> > >> >> Soekris net4801. For 4 ports you'd need 4 Sipuras and I don't know
> > >> >> whether it could handle that many.
> > >> >>
> > >> >> Graham
> > >> >>
> > >> >>
> > >> > _______________________________________________
> > >> > Soekris-tech mailing list
> > >> > Soekris-tech at lists.soekris.com
> > >> > http://lists.soekris.com/mailman/listinfo/soekris-tech
> > >> >
> > >> >
> > >> >
> > >>
> > >> _______________________________________________
> > >> Soekris-tech mailing list
> > >> Soekris-tech at lists.soekris.com
> > >> http://lists.soekris.com/mailman/listinfo/soekris-tech
> > >>
> > >
> > >
> >
> >
> _______________________________________________
> Soekris-tech mailing list
> Soekris-tech at lists.soekris.com
> http://lists.soekris.com/mailman/listinfo/soekris-tech
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.soekris.com/pipermail/soekris-tech/attachments/20060820/e31c7a79/attachment.html
More information about the Soekris-tech
mailing list