[Soekris] 4801 and NetGate 802.11a/b/g

Sam Leffler sam at errno.com
Sat Nov 8 23:51:04 UTC 2003


On Saturday 08 November 2003 12:10 pm, John Bellardo wrote:
> Jason,
>
> On Nov 8, 2003, at 10:51 AM, Jason Romo wrote:
> > Has anyone tried to use the Netgate 802.11a/b/g combo mini-pci card as
> > an
> > AP?  Looking to setup the Net 4801 as an AP.  Found the Madwifi
> > drivers and
> > can't confirm if it supports AP mode. I have found vytek.com that has
> > software for it but it is not opensource.  I would rather have an
> > opensource
> > solution.
> >
> > Any links or information would be appreciated.
>
> I have a 4801 with the Netgate a/b/g setup as an AP in my lab.  I'm
> using the madwifi driver, and it has work reasonably well so far.  It
> still has some rough edges though.  For example, last time I tried
> using g mode it wasn't working.  The other annoying feature of the
> netgate card is the four antenna jacks (2 each for a and b/g).
> Basically, you need to decide which frequency range you want to use
> before you deploy your AP.  Switching typically requires changing where
> the pigtails are plugged in to the wireless card.  The most
> inconvenient aspect of the 4801 so far has been the soekris enclosure.
> It doesn't have holes for the pigtails, so you have to add your own.  I
> can get reasonable throughput with the setup.  Typically 20-25 mbps
> using .a (in a "clean" environment) as measured by netperf's TCP stream
> test.

11g required an addition to the HAL to set the slot time.  That's just been 
added so there should be 11g support soon.  Regardless, it does have some 
rough edges for 5212-based cards.

	Sam




More information about the Soekris-tech mailing list